OSDev.org https://forum.osdev.org/ |
|
Virtualbox issues https://forum.osdev.org/viewtopic.php?f=1&t=36722 |
Page 1 of 1 |
Author: | alextaffe [ Tue Apr 28, 2020 8:33 am ] |
Post subject: | Virtualbox issues |
I’m working on developing my own OS for a class. The OS boots fine on qemu and real hardware. However, I cannot for the life of me make it work on Virtualbox or DOSBox, which I need for Soundblaster 16 direct mode (QEMU only supports DMA transfers). I’m running the OS with: Code: qemu-system-i386 \ -cpu "SandyBridge-v2" \ -m 256M \ -no-reboot \ -drive format=raw,file=usb.image \ -serial stdio \ -smp 1 \ -usb \ -vga std \ -soundhw sb16 DOSBox can work with the .img file natively, for Virtualbox I’m using the following command to link a VMDK to the img. I’ve tried selecting the DOS preset, Other preset, and Other 64 bit preset: Code: VBoxManage internalcommands createrawvmdk -filename OS.vmdk -rawdisk os.img We were given a boot loader and it seems to always fail here: Code: /* ** Read one complete program block into memory. ** ** ax: number of sectors to read ** es:bx = starting address for the block */ readprog: pushw %ax /* save sector count */ movw $3,%cx /* initial retry count is 3 */ retry: pushw %cx /* push the retry count on the stack. */ movw sec,%cx /* get sector number */ movw head,%dx /* get head number */ movb drive, %dl movw $0x0201,%ax /* read 1 sector */ int $0x13 jnc readcont /* jmp if it worked ok */ movw $err_diskread,%si /* report the error */ call dispMsg popw %cx /* get the retry count back */ loop retry /* and go try again. */ movw $err_diskfail,%si /* can't proceed, */ call dispMsg /* print message and freeze. */ jmp . In Virtualbox and DOSBox, the OS just spits out "Read failed" 3 times and "Can’t proceed” before halting (those strings are constants in the boot loader). I haven’t had luck with getting Bochs to even attempt to start. My guess is some offset is wrong and the boot loader is failing to calculate where it’s supposed to be reading from, or interrupt 0x13 isn’t working properly due to the virtual motherboard being configured incorrectly. I’m just confused as to why it works on real hardware and qemu but not Virtualbox nor DOSBox. |
Author: | Octocontrabass [ Fri May 01, 2020 1:45 am ] |
Post subject: | Re: Virtualbox issues |
You haven't included enough information to say exactly what's wrong, but the most common mistake in legacy BIOS bootloader development is using uninitialized registers. It could also be a problem in how the CHS address is being calculated. |
Author: | iansjack [ Fri May 01, 2020 3:25 am ] |
Post subject: | Re: Virtualbox issues |
Have a look here for suggestions as to how to use a raw disk image with VirtualBox. https://lira.epac.to/MyPublicWiki/VBox: ... alBox.html |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |