| OSDev.org https://forum.osdev.org/ |
|
| Page fault handler causes read data to be corrupt? https://forum.osdev.org/viewtopic.php?f=1&t=32652 |
Page 1 of 1 |
| Author: | kc9zda [ Thu Dec 28, 2017 10:12 am ] |
| Post subject: | Page fault handler causes read data to be corrupt? |
It seems after I map a page in my page fault handler, the data at the paged address is corrupt on the first read, but fine on the second. Here is my page fault handler: Code: .globl exception_page_fault .align 4 exception_page_fault: cld push %esp call pg_fault add $0x08,%esp # 4 bytes for error code, 4 bytes for saved ESP iret The signature for pg_fault in C: Code: void pg_fault(uint32_t esp, uint32_t ec); // esp = ESP upon entry to fault handler; ec = error code Currently, when pg_fault is called, it identity maps the page that isn't present. It's a temporary solution so I can read ACPI tables while paging. I have a test that shows that shows the Length field in the RSDT table: Code: printf("first try: %u\n", acpi_rsdt->length); printf("second try: %u\n", acpi_rsdt->length); The first try triggers a page fault, which identity maps the page. The first read attempt returns something resembling a real mode address in the ROM (like a vector in the IVT). The second try returns the correct value. I would expect both of these to be the same. It even reads fine in the page handler right after reloading CR3 and calling INVLPG on the address. I'm pretty sure there is something wrong with my assembly page fault handler, but I can't tell what it is. I'm using Virtualbox 4.3.10. |
|
| Author: | Korona [ Thu Dec 28, 2017 10:34 am ] |
| Post subject: | Re: Page fault handler causes read data to be corrupt? |
The ABI does not guarantee that all registers are saved by pg_fault(). You need to look up which registers are caller-saved in your ABI and manually save and restore them. |
|
| Author: | xenos [ Thu Dec 28, 2017 10:35 am ] |
| Post subject: | Re: Page fault handler causes read data to be corrupt? |
I would assume that your interrupt handler corrupts the interrupted code's registers. Where do you save / restore them? |
|
| Author: | kc9zda [ Thu Dec 28, 2017 10:58 am ] |
| Post subject: | Re: Page fault handler causes read data to be corrupt? |
I did not consider saving registers. I am using the sysV ABI (i686-elf), which saves EBX, ESI, EDI, EBP, and ESP. I found that if I do a PUSHA at the beginning and a POPA before the IRET and stack adjustment (for error codes), it works fine. Thanks |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|