Serial initialized.
[INIT] Mapped memory
[INIT] GDT Enabled
[INIT] IDT Enabled
[INIT] Paging initialized
[INIT] Kernel heap initialized
[AHCI] Searching for SATA drives. Details below.
[INIT] Initialized AHCI driver
[INIT] Initialized Syscalls.
[INIT] Tasking initialized.
[UHCI] IOBase: C020
[UHCI] Allocated 2 pages at vaddr:1032000 paddr:832000
[UHCI] Enabled USB stack for controller
[UHCI] Port 0 determined valid.
[UHCI] Port 0 reset but nothing attached.
[UHCI] Reset port 0
[UHCI] Port 1 determined valid.
[UHCI] Port 1 reset but nothing attached.
[UHCI] Reset port 1
[UHCI] Reset 2 ports.
[UHCI] Finished initializing UHCI controller.
[xHCI] Base Address: C0000000
[xHCI] Ops Address: C0000020
[xHCI] Controller version: 100
0 1 1 0
0 0 0 0
0 0 0 0
0 0 0 0
[xHCI] Clear RunStop
[xHCI] Cleared RunStop
[xHCI] Resetting xHCI.
[xHCI] Reset xHCI Controller Globally
[xHCI] BIOS Ownership released
[xHCI] Reset xHCI Globally
[xHCI] Detected 4 ports
[xHCI] Found 2 USB 2 ports and 2 USB 3 ports.
[xHCI] Port 0: USB 3 Paired, Phys 0, PortPair 2
[xHCI] Port 1: USB 3 Paired, Phys 1, PortPair 3
[xHCI] Port 2: USB 2 Paired, Phys 0, PortPair 0
[xHCI] Port 3: USB 2 Paired, Phys 1, PortPair 1
[xHCI] No port reset change on 0
[xHCI] Reset port 0 (USB3) FAILED
[xHCI] Reset port 2 (USB2) SUCCESS
[xHCI] Attempting to initialize device
[xHCI] Max Packet Size: 64
Routing: 0
08000000 00010000 00000000 00000000 00000000 00000000 00000000 00000000 
00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 Param: 88A000
Status: 0
Command: 1002C00
Error: SetAddress returned 4000000
[xHCI] Set address failed.
[xHCI] No port reset change on 1
[xHCI] Reset port 1 (USB3) FAILED
[xHCI] No port reset change on 3
[xHCI] Reset port 3 (USB2) FAILED
[USB ] Assigning drivers to devices...
[INIT] Initialized USB driver
[KMSG] Kernel initialized successfully